A systematic approach to the control of esthetic form

doi:10.1016/0022-3913(76)90006-8

The Journal of Prosthetic Dentistry

Volume 35, Issue 4, April 1976, Pages 393-402

https://doi.org/10.1016/0022-3913(76)90006-8 Get rights and content

Abstract

A systematic, orderly approach to the problem of establishing harmonious phonetics, esthetics, and function in fixed restorations has been described. The system requires an initial investment of time in performing an adequate diagnostic waxing, but recoups that time in many clinical and laboratory procedures. The method has proved a valuable asset in fixed prosthodontic care. The technique can be expanded and combined with other techniques with a little imagination and artistic bent.

Reference (7)

BralyB.V.
A Preliminary Wax-up as a Diagnostic Aid in Occlusal Rehabilitation
J. Prosthet. Dent.
(1966)
MorganD.W. et al.
A Diagnostic Wax-up Technique
J. Prosthet. Dent.
(1975)
HirschB. et al.
Effects of Dentist Authoritarianism on Patient Evaluation of Dentures
J. Prosthet. Dent.
(1973)

There are more references available in the full text version of this article.

Cited by (53)

A technique for improving the fit of a vacuum-formed matrix
2016, Journal of Prosthetic Dentistry
Severe and rapid erosion of dental enamel from swimming: A clinical report
2011, Journal of Prosthetic Dentistry
Citation Excerpt :
However, upon repeated pronunciation of “S” sounds, while counting from 60 to 70, excessive minimum speech distance in the canine and premolar regions was measured to be 3 to 4 mm. The patient's smile was affected by the deficient length of the remaining tooth structure as well as by the exposed shade of dentin.22–24 The patient was diagnosed with severe and rapid enamel erosion.
The diagnosis and treatment of a patient with excessive and rapid erosion of enamel is presented. Although the Center for Disease Control and the dental literature have reported on dental enamel erosion resulting from swimming pool chlorination, the awareness of such etiology among dental professionals may be limited. Common findings in these reports include cold sensitivity, a distinctive appearance resembling laminate veneer preparations of the facial surfaces of anterior teeth, occurrence of diastemas, and at times, a rough or gritty texture of the remaining tooth structure. Clinical presentations of erosive lesions can be diagnosed and the best course of treatment determined.
A multidisciplinary approach for treating congenitally transposed canines: A clinical report
2006, Journal of Prosthetic Dentistry
Citation Excerpt :
The composite resin was light polymerized for 30 seconds (Coe Lunar TA curing light; GC America Inc, Alsip, Ill); the vacuum-formed matrix was then removed and esthetics and phonetics were assessed.20,21 The maxillary canines, lateral incisors, and first premolars were prepared for bonded labial veneers and the vacuum-formed matrix was used to evaluate the preparation reduction (Fig. 7).22,23 Definitive impressions were made using an elastomeric impression material (medium body Reprosil; Dentsply Caulk, Milford, Del), and interim restorations were fabricated using a composite resin (Vitalescence; Ultradent) applied with the previously fabricated vacuum-formed matrix.
Long-term effects of storage and thermal cycling on the marginal adaptation of provisional resin crowns: A pilot study
2006, Journal of Prosthetic Dentistry
Provisional resin crowns may be used for an extended period while complex treatments are completed. The crowns function intraorally; therefore, moisture absorption and thermal cycling may affect the physical properties of acrylic resin, causing a change in marginal gap size.
The purpose of this pilot study was to examine the effect of long-term water absorption and thermal cycling on marginal gap size of polymethyl methacrylate copolymer and bis-acrylic composite resin crowns.
Specimens (n=10) were fabricated from 2 acrylic resins: a polymethyl methacrylate (Alike) and a bis-acrylic composite resin (Provitec). Specimens were first fabricated on a metal master die. Custom die stems were fabricated for each specimen from a low-fusing alloy (Cerroblend) to eliminate the factor of polymerization shrinkage. Specimens were then fitted to assure a standardized, pre-experimental marginal gap range of ≤ 25 μm. Specimens were stored in a humidor at 37°C and 97% relative humidity for 1 year and subsequently thermal cycled (5°C to 60°C, 6-second dwell time, for 8000 cycles). Measurements in micrometers of the marginal gap were recorded using a microscope equipped with a digital video camera and image analysis software before and after treatment. A 2-way analysis of variance with a split design was performed for factors of materials and treatment (α=.05).
For the factor of material, there was no significant difference; however, there was a significant difference between treatments, with a significantly greater increase in marginal gap size after thermal cycling (P<.002).
Provisional crowns made from either a bis-acrylic resin composite or a polymethyl methacrylate copolymer demonstrated loss of marginal adaptation during a simulated long-term period of service.
A simplified custom impression technique
2005, Journal of Prosthetic Dentistry
A review of selected dental literature on contemporary provisional fixed prosthodontic treatment: Report of the Committee on Research in Fixed Prosthodontics of the Academy of Fixed Prosthodontics
2003, Journal of Prosthetic Dentistry
One goal of the American Academy of Fixed Prosthodontics is regularly to publish comprehensive literature reviews on selected topics germane to the discipline of fixed prosthodontics. The following report is the result of this goal and focuses on provisional fixed prosthodontic treatment. Major subtopics include materials science and clinical considerations involving natural teeth and dental implants. The interrelationship between provisional and definitive fixed prosthodontic treatment is multifaceted and significant. Provisional therapy involves numerous materials and techniques that require special knowledge and technical experience. In this analysis, technical, clinical, and investigational articles are detailed and presented as a comprehensive literature review to provide contemporary guidelines. Referenced publications were found by conducting a Medline search and were limited to peer-reviewed, English-language articles published from 1970 to the present. Materials used with provisional treatment are discussed in terms of clinical selection and the influence of their physical properties on treatment outcome. Specific product names and manufacturers are included in this report only when they are cited in the original referenced publications.

View all citing articles on Scopus

: Read before the Pacific Coast Society of Prosthodontists, San Diego, Calif.

^*: Director, Resident Training Program in Fixed Prosthodontics.

¹: 5062 Amestoy Ave. Encino, Calif. 91316.

View full text

A systematic approach to the control of esthetic form

Abstract

J. Prosthet. Dent.

J. Prosthet. Dent.

J. Prosthet. Dent.