Fixation strengths of patellar tendon-bone grafts*

https://doi.org/10.1016/S0749-8063(05)80348-2Get rights and content

Summary

Secure fixation of bone-patellar tendon-bone grafts is essential to allow early joint mobilization after anterior cruciate ligament (ACL) reconstruction surgery. This study was designed to evaluate four fixation methods of patellar tendon-bone grafts in cadaveric knecs. Fifty-one fresh cadaveric patellar tendon-bone specimens were anchored in tibial or femoral metaphyseal bone tunnels. Group I grafts were fixed with Kurosaka interference screws. In Group II the grafts were initially fixed as in Group I, but the screws were then removed, the bone plugs repositioned, and the grafts resecured with screws. In Group III the grafts were anchored with three no. 2 nonabsorbable sutures tied over a screw and washer, whereas in Group IV no. 5 nonabsorbable sutures were used. Each bone specimen was mounted in the biomechanical testing machine, and a vertical tensile load was applied at a strain rate of 51 cm/min until failure of fixation, bone plug fracture, or tendon disruption occurred. The mean force to failure in Groups I, II, III, and IV were 435.0 N, 458.2 N, 454.2 N, and 415.8 N, respectively. There was no significant difference in the force to failure among the four methods of fixation. However, the modes of failure were diverse. In three specimens the Kurosaka screws diverged from the plugs and failed to achieve fixation. These specimens were excluded and will be discussed separately. Although technique-related difficulties may arise, interference screw fixation of patellar tendon-bone grafts affords strong graft fixation—often stronger than the graft itself. Secondary screw fixation appears to be equal in strength to primary screw fixation. Fixation with sutures tied over a screw post is dependent on the strength of the suture. No. 5 nonabsorbable suture material consistently provided fixation stronger than the patellar tendon grafts. These four methods may provide fixation strengths in excess of forces normally experienced by the ACL during the early rehabilitative period.

References (10)

  • MatthewsLS et al.

    Pitfalls in the use of interference screws for anterior cruciate ligament reconstruction: a brief report

    J Arthrosc

    (1989)
  • JonesKG

    Reconstruction of the anterior cruciate ligament. A technique using the central one-third of the patellar ligament

    J Bone Joint Surg

    (1963)
  • ClancyWG et al.

    Anterior cruciate ligament reconstruction using one-third of the patellar ligament augmented by extra-articular tendon transfers

    J Bone Joint Surg

    (1982)
  • PaulosLE et al.

    Intra-articular cruciate reconstruction

    Clin Orthop

    (1983)
  • AmisAA

    The strength of artificial ligament anchorages: a comparison experimental study

    J Bone Joint Surg

    (1988)
There are more references available in the full text version of this article.

Cited by (0)

*

This article was presented at the Arthroscopy Association of North America Annual Meeting, April 26, 1990, in Orlando, Florida, and at the American Society for Sports Medicine, June 14, 1990, in Sun Valley, Idaho.

1

From the Department of Orthopaedic Surgery, Union Memorial Hospital, Baltimore, Maryland, U.S.A.

View full text