Metal-on-metal hip prostheses: where are we now?
BMJ 2012; 345 doi: https://doi.org/10.1136/bmj.e7792 (Published 16 November 2012) Cite this as: BMJ 2012;345:e7792- J Mark Wilkinson, professor of orthopaedic surgery
- 1University of Sheffield, Sheffield S10 2RX, UK
- j.m.wilkinson{at}sheffield.ac.uk
In the late 1950s John Charnley, working in the north of England, introduced Teflon as a joint bearing surface material in his then visionary “low friction” hip joint replacement. Initial clinical success was soon followed by catastrophic mechanical failure and local tissue destruction owing to foreign body soft tissue reactions, and the use of Teflon in prostheses was abandoned by 1962.1 Fifty years later this cycle of promising innovation followed by unforeseen complications seems to be repeating itself with metal-on-metal hip prostheses that use large diameter (≥36 mm) bearings.
Charnley’s solution was to use high density polyethylene, and this is still a good choice of bearing material for older patients. However, in young patients with high physical demands, polyethylene prostheses wear out too quickly and often need to be revised. The introduction of hard wearing contemporary metal-on-metal bearings in the 1990s promised an end to prosthesis failure related to wear debris and better biomechanical function owing to the larger more natural diameter of the replaced joint. Initial enthusiasm led to about a million of these bearings being inserted worldwide during the past decade. However, reports of poor …
Log in
Log in using your username and password
Log in through your institution
Subscribe from £173 *
Subscribe and get access to all BMJ articles, and much more.
* For online subscription
Access this article for 1 day for:
£38 / $45 / €42 (excludes VAT)
You can download a PDF version for your personal record.