Background
Over the last decade, a growing number of patients have benefited from extracorporeal membrane oxygenation (ECMO) as rescue therapy for patients suffering from severe acute respiratory distress syndrome (ARDS) or refractory cardiogenic shock [
1]. More than half of them will require antibiotic therapy during their ECMO run to treat a primary infection or secondary acquired infection [
2]. Because little is known about the impact of ECMO on antibiotic pharmacokinetics (PK), antibiotic administration on ECMO remains a challenge. Although suboptimal antibiotic dosing in this complex group of patients may have fatal consequences, available data are actually limited to animal [
3], simulated ex-vivo [
4], or small retrospective human studies [
5]. Sequestration in the circuit, increased volumes of distribution (Vd), and decreased drug clearance have been implicated to explain antibiotic–PK modifications in that context [
6]. Moreover, the underlying disease in these extremely severely ill patients may also be key. Empirical combination antibiotic therapy, aimed at covering Gram-negative bacilli, usually combines a β-lactam and an aminoglycoside [
7]. Considering its good bactericidal activity against
Pseudomonas aeruginosa and its low resistance rate observed with other Gram-negative bacilli, amikacin is frequently used in that context [
8]. Its antibacterial effect is determined by the ratio of peak serum concentration (C
max) to the targeted pathogen’s minimal inhibitory concentration (MIC), with optimal antibacterial activity obtained with a C
max/MIC ratio of 8–10. Consequently, the amikacin C
max range should be 64–80 mg/L [
9], while the most recent French guidelines recommended C
max > 60 mg/L [
10]. Despite administering an amikacin dose of 25 mg/kg total body weight (TBW), only 67–72% of intensive care unit (ICU) patients have been found to achieve that objective [
11,
12]. In this setting, further PK changes in ECMO-treated patients would be anticipated. Therefore, this open-label, monocentric, prospective study was designed to determine the frequency and identify factors predictive of insufficient amikacin C
max in critically ill patients, and to analyze the probability of attaining the established PK target (i.e. greater than 60 mg/L but below 80 mg/L).
Methods
Setting
This prospective observational study was conducted in a 26-bed medical–surgical ICU at a university hospital. Its protocol was in accordance with the ethical standards of our hospital’s Institutional Review Board (Committee for the Protection of Human Subjects). In accordance with French law, informed consent was not obtained for demographic, physiological and hospital-outcome data analyses because this observational study did not modify existing diagnostic or therapeutic strategies. However, patients and/or relatives were informed about the anonymous data collection and that they could decline inclusion. This database was registered at the Commission Nationale l’Informatique et des Libertés (CNIL, registration number 1950673).
Study design and patients
We prospectively included all consecutive patients, from January 2015 through February 2016, who received an intravenous amikacin loading dose for suspected Gram-negative infection in a context of venoarterial (VA) or venovenous (VV) ECMO in our ICU. Only the first dose of amikacin was studied. Four types of ECMO systems with poly-4-methyl-1-pentene membrane oxygenators (PLS system, Cardiohelp system, both Maquet, Rastatt, Germany; Hilite 7000 LT system, Medos, Stolberg, Germany; ECC.05 system, Sorin, Mirandola, Italy) were used during the study period. Exclusion criteria were (1) incorrect amikacin regimen (< 23 or > 27 mg/kg TBW); (2) incorrect time of amikacin infusion (± 5 min); or (3) incorrect time (± 5 min) or absence of Cmax determination. Patients with incorrect time of trough serum concentration (Cmin) determination (± 1 h) were not excluded if Cmax had been obtained correctly.
Amikacin administration and serum-concentration dosage
Amikacin was administered according to our ICU’s written standardized protocol: 25 mg/kg TBW (weighing bed weight of the day), diluted in 50 mL of 0.9% NaCl and continuously infused over 30 min. When the patient’s weight was > 120 kg, a maximum of 120 kg was considered to calculate the loading amikacin dose (five patients in our study). C
max was assessed 30 min after that infusion ended and C
min 24 h after the latter. Our Microbiology Laboratory used a fluorescence-polarization immunoassay to determine amikacin concentrations, as a routine procedure available 24 h/day, 7 days/week [
13].
Data collection
Demographic data, Simplified Acute Physiology Score (SAPS) II [
14], and reason for ECMO were collected for all patients. ECMO-membrane duration was defined as the delay between membrane first use and the time of amikacin infusion. Organ dysfunction at inclusion (i.e. the day of amikacin administration) was assessed with the Sequential Organ-Failure Assessment (SOFA) score. In addition, laboratory tests, including coagulation parameters, complete blood count, electrolytes, liver enzymes, urea, creatinine, and bilirubin, were run. At inclusion, the inotrope score was calculated [
15], defined as:
Dobutamine dose (γ/kg/min) + [Norepinephrine dose (γ/kg/min) + Epinephrine dose (γ/kg/min)] × 100.
The 24-h fluid balance was defined as the difference between fluid intake and fluid output over the 24 h before amikacin infusion. Proteinemia and hematocrit changes during the 24 h preceding inclusion were calculated as follows:
(X0h – X24h)/(X0h + X24h)/2.
In addition, renal function was characterized according to the Kidney Disease: Improving Global Outcomes (KDIGO) classification [
16]. Acute renal failure in ICU survivors was defined as KDIGO ≥ 2. Lastly, infection sites and identified pathogens were noted.
Statistical analyses
Categorical variables are expressed as number (percentage) and compared using the chi-square test. Continuous variables are expressed as medians (1st; 3rd quartile) and compared using Student’s
t test or Wilcoxon’s signed-rank test. Pre-amikacin infusion factors associated with a C
max < 60 mg/L or a C
max > 80 mg/L were selected using univariable mixed models. Demographics and clinical and biological factors with a
p value ≤0.10 in our univariable analyses were entered into the multivariable mixed model. The list of data entered in both models is provided in Additional file
1: Table S1. Few relevant variables with a plausible clinical link despite a value of
p > 0.10 in the univariate analysis were forced into the models (Additional file
1: Table S1). Continuous variables were transformed into categorical variables (the optimal thresholds were defined by analyzing mortality in each corresponding variable quartile). Thereafter, multiple backward-stepwise logistic-regression analyses eliminated variables with an exit threshold set at
p > 0.05. All potential explanatory variables included in the multivariable analyses were subjected to collinearity analysis with a correlation matrix. In the case of collinearity between factors, the most clinically relevant factor was chosen to construct the multivariable model. Results are reported as odds ratios (ORs) and their 95% confidence intervals (CIs).
Given the observed C
max and the administered dose/kilogram, we assumed amikacin PK linearity [
17‐
20] to simulate individual C
max for the following dosing regimen: 20 mg/kg, 25 mg/kg, 30 mg/kg, 35 mg/kg TBW. In order to provide dosing regimen recommendations, for each dosing regimen, we estimated the probability of C
max in the therapeutic range (60–80 mg/L) for the different categories of the risk factors found predictive of under-dosing in the multivariable analysis.
Analyses were computed using StatView v5.0 (SAS Institute, Cary, NC, USA), SPSS v22.0 software (SPSS, Chicago, IL, USA) and R v3.3.0 (
http://www.R-project.org).
Discussion
The results of our large prospective study indicate that amikacin under-dosing on ECMO after a loading dose of 25 mg/kg TBW is frequent, with more than a third of the patients having C
max < 60 mg/L. In addition, using a 25 mg/kg amikacin dosing regimen led to 64% of patients with a C
max outside the targeted range of 60–80 mg/L. Independent risk factors for amikacin under-dosing were BMI < 22 kg/m
2 and positive 24-h fluid balance, in agreement with previous studies without ECMO [
17‐
20]. No association between under-dosing or overdosing of amikacin and outcome was found. Last, dosing simulations might suggest to increase the amikacin dosing regimen up to 30 mg/kg and 35 mg/kg TBW when 24-h fluid balance is positive and the BMI is > 22 kg/m
2 or the BMI is < 22 kg/m
2, respectively.
Describing antibiotic PK in the population on ECMO is essential to understand whether special dosing may be required. Unfortunately, such data on ECMO-treated adults are sparse and the available literature is mainly restricted to ex-vivo studies [
4,
6,
21]. Systemic inflammatory responses, organ dysfunction, drug interactions and organ support are all known to affect antibiotic PK in critically ill patients. Drug PK seems to be more markedly modified on ECMO [
6]. General PK parameters of hydrophilic antibiotics, like aminoglycosides, are low Vd, predominantly with renal clearance, and low intracellular penetration [
22].
Recently, in a large case series of 146 severely ill patients receiving 181 amikacin infusions, including 15% on ECMO, C
max was < 60 mg/L during 33% of the episodes. Independent risk factors were BMI < 25 kg/m
2 and positive 24-h fluid balance [
11]. Although many factors, e.g. the extracorporeal circuit, high-volume fluid infusion and the extreme severity of critical illness in the patients could contribute to a larger Vd on ECMO, we found similar frequencies of amikacin under-dosing and overdosing with the same risk factors. Based on a smaller cohort of 46 ECMO-treated patients, Gelisse et al. reported a similar percentage of C
max insufficiency, when matched with critically ill patients without ECMO support [
5]. We postulate that, as demonstrated without ECMO [
19‐
21], the intensity of interstitial fluid shift during sepsis on ECMO will result in a larger Vd, which might lower plasma antibiotic concentrations. It is worth noting that the increased Vd in septic patients may be attributed to hypoalbuminemia and the resulting decreased oncotic pressure [
22], which was low in our population.
Low BMI (i.e. < 22 kg/m
2) was the second independent risk factor for C
max < 60 mg/L, which agrees with published observations [
11,
12]. With hydrophilic drugs, like amikacin, using TBW for dose calculation in high-BMI patients, instead of ideal body weight or adjusted body weight, could overestimate amikacin Vd. Indeed, higher BMI was the only factor that was independently associated with a higher risk of overdosing in our study. Surprisingly, although, a poor TBW–Vd relationship has been thoroughly described, the amikacin loading dose is still commonly adjusted to TBW. Therefore, we cannot rule out the fact that using adjusted body weight in obese patients [
23] would have led to different findings.
Notably, Allou et al. [
24] and Galvez et al. [
25] reported, without a clear explanation, that amikacin overexposure (i.e. C
max > 80 mg/L) might potentially be associated with increased mortality. Although, our study was not designed to analyze mortality, we did not observe any C
max–mortality association. Moreover, an amikacin C
min > 2.5 mg/L was not significantly associated with a higher AKI rate at ICU discharge. Considering the high amikacin under-dosing frequency in our ECMO-treated patients and our dosing simulations, our dosing simulation suggests that increasing the loading dose up to a 35 mg/kg TBW dose for low-BMI patients and those with positive 24-h fluid balance on ECMO could help to obtain adequate target concentrations. However, these dosing simulations deserve to be confirmed by future prospective studies or Monte-Carlo-based simulations. Less frequent under-dosing has also been reported without a higher AKI rate, using a higher loading dose [
24,
26]. However, despite the current trend toward increasing antibiotic doses in ICUs, no beneficial effect on outcome has been clearly demonstrated. In addition, it can be argued that a lower amikacin C
max might be enough to obtain C
max/MIC > 8 for most isolated strains that often have amikacin MICs ≤ 4 mg/L [
26].
Our study’s strengths include the large cohort investigated, focusing on the impact of ECMO, its longitudinal design and a short interval retained for the correct time of C
max determination. However, it also has limitations. First, it is a single-center study in an ICU with a high volume of ECMO cases in a tertiary-care university hospital, and our results may not be generalizable to all ICUs. Second, our ECMO population was a mix of patients who received VA-ECMO and VV-ECMO support, with different outcomes and underlying illnesses. Given that the underlying diseases of these extremely ill patients is key in antibiotic PK modifications on ECMO, our results might have been different if we had focused on a subpopulation of patients on ECMO (i.e. those with cardiac or respiratory failure). However, our multivariable analysis did not identify reasons for ECMO and type of ECMO hook-up as factors predictive of C
max < 60 mg/L. Third, we cannot exclude that coadministration with another antibiotic and other ICU treatments might also have contributed to AKI at ICU discharge. Fourth, our dosing simulation was based on amikacin PK linearity [
17‐
20] and a limited number of patients (
n = 11) with positive 24-h fluid balance and BMI < 22 kg/m
2. And finally, we cannot rule out that a portion of amikacin might have been sequestrated on the ECMO membrane, as previously described on the hemofilter membrane [
27].